University of Surrey

Test tubes in the lab Research in the ATI Dance Research

Investigation of powder flowability at low stresses by DEM modelling

Stavrou, Alexandros Georgios, Hare, Colin, Hassanpour, Ali and Wu, Chuan-Yu (2020) Investigation of powder flowability at low stresses by DEM modelling Chemical Engineering Science, 211, 115307.

[img] Text
Stavrou et al., 2019_author_accepted_version.pdf - Accepted version Manuscript
Restricted to Repository staff only until 22 October 2020.

Download (1MB)

Abstract

Ball indentation is a technique capable of assessing powder flowability down to very low consolidation stresses (≤1 kPa). With this method, powder flowability is determined by measuring the hardness of a powder bed, which allows the unconfined yield strength to be inferred via the constraint factor. The latter is well established for continuum materials, whereas for particulate systems its dependency on stress level and powder properties is not well defined. This work investigates these factors by simulating the ball indentation method using DEM. The constraint factor is shown to be independent of pre-consolidation stress. Constraint factor generally increases with interface energy for relatively cohesion-less powders, though not for cohesive powders. An increase in plastic yield stress leads to a decrease in the constraint factor. Increasing the coefficient of interparticle static friction reduces the constraint factor, while increasing the coefficient of inter-particle rolling friction significantly increases the constraint factor.

Item Type: Article
Divisions : Faculty of Engineering and Physical Sciences > Chemical and Process Engineering
Authors :
NameEmailORCID
Stavrou, Alexandros Georgiosa.stavrou@surrey.ac.uk
Hare, Colinc.hare@surrey.ac.uk
Hassanpour, Ali
Wu, Chuan-Yu
Date : 16 January 2020
DOI : 10.1016/j.ces.2019.115307
Copyright Disclaimer : Copyright 2019 Elsevier Ltd. All rights reserved.
Uncontrolled Keywords : Powder flowability; Low consolidation stresses; Ball indentation; Shear cell; DEM modelling
Additional Information : The financial support of the International Fine Particle Research Institute (IFPRI) is gratefully acknowledged. Furthermore, the authors greatly appreciate the MATLAB code provided by Dr. Massih Pasha (The Chemours Company) for the calculation of the input parameters for the DEM contact model used in this work.
Depositing User : Diane Maxfield
Date Deposited : 08 Jan 2020 16:13
Last Modified : 08 Jan 2020 16:13
URI: http://epubs.surrey.ac.uk/id/eprint/853300

Actions (login required)

View Item View Item

Downloads

Downloads per month over past year


Information about this web site

© The University of Surrey, Guildford, Surrey, GU2 7XH, United Kingdom.
+44 (0)1483 300800