Influence of the Fabrication Process on the Performance of X-Band Filters
Ali, W M, Min, C and Free, C E (2007) Influence of the Fabrication Process on the Performance of X-Band Filters Proceedings of Asia-Pacific Microwave Conference . pp. 1191-1194.
|PDF - Published Version|
Official URL: http://dx.doi.org/10.1109/APMC.2007.4554827
Growing demand for mobile and wireless communication systems has generated much interest in low-cost, high quality microwave fabrication technologies. The performance of these systems relies on not only excellent design and analysis but also the characteristics of materials and their corresponding fabrication technologies. Often the designer is faced with a compromise between satisfying the high performance demands of a microwave component, and achieving low fabrication cost. This paper studies feasibility of realizing microwave bandpass filters using thick film screen printing techniques. The measured and simulated results for a 9.5GRz edge coupled bandpass filter have been determined and compared.
|Additional Information:||©2007 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.|
|Divisions:||Faculty of Engineering and Physical Sciences > Electronic Engineering > Advanced Technology Institute > Nano-Electronics Centre|
|Deposited By:||Mr Adam Field|
|Deposited On:||27 May 2010 15:38|
|Last Modified:||24 Oct 2012 10:38|
Repository Staff Only: item control page